Пока без изменений..

Hi Worders,

no problem is still present, but it is from case to case, in some cases it works without problems but in my case it is not working. Problem is still present .

HI All,

Last night I try to reflash nodemcu dev board and got ds sensro to work, 1-wire scan sensor, I will try to attach few more to see how it will play. So steps I have done:

First of all it works on gpio5, now please check first gpio on board where you attach data pin of DS18B20 sensor! I try with pin 12, 10... and fials to show sensor on 1-wire scanning page.

I will attach my FW setting before I have generate new FW.

If I find something else I will share here.

Thanks

I had problems detecting sensor DS18B20 as well. I tried to recompile the firmware few times, and found that when activated the support to Thingspeak and MQTT together, the detection of sensor failed. When compiling the firmware with only one option, everything worked normally.

DS18B20 у меня заработал ТОЛЬКО на ОБЛЕГЧЕННОЙ прошивке 0.9.5 на GPIO-3. На остальных ногах пока не проверял. Все остальные скомпилированные на сайте прошивки (1.3 1.2 1.0.1) с датчиком не заработали.

Тут закономерность выявлена, что с ОТА работает, без ОТА - нет. от SDK не зависит.